The Peacemaker Micro Dagger tune-up kit
(DOES NOT FIT A G43/48/43X)
Are you tired of that hinged polymer trigger that was stolen from your grandfather’s Smith and Wesson? How about that break which creeps worse than an OnlyFans simp? Don’t fret and don’t waste your money on half ass ‘Performance’ triggers off of Ebay…. TacticalPontoon has you covered with my tune-up kit!
What do you get with this kit? Why choose TacticalPontoon?
Instead of fighting some roll pin in the trigger shoe (one wrong move and you beat up your new trigger) this kit uses the trigger from the Peacemaker which has a screw to make install a breeze! Most kits will send out their ‘performance’ connector, but I have not found any aftermarket slimline connector that isn’t just a mush factory. The connector that comes with the Micro is perfectly fine in this instance. The new trigger spring clips right in The striker spring and safety plunger springs swap out in a few minutes with just a quick removal of the slide plate…..squirt on the included Badger Snot…then hit the range to enjoy the new hotness!!! This kit drops the weight of the trigger system down by 1.0-1.25lbs and keeps it crisp!
Check out the full value of this kit below;
- Peacemaker trigger shoe
- overpowered trigger spring
- squeeze tube of Badger Snot
- reduced weight duty rated striker spring (lighter weight than stock)
- reduced weight safety plunger spring
- *optional* TacticalPontoon polished and tuned G43x connector (If you have had connector issues with the Micro Dagger and want to upgrade to one of my tuned Glock connectors, this is your option. I don’t think the PSA connector is bad, but this is the connector I use in my full trigger systems.)
- Want a full trigger system? The Peacemaker Extreme Carry is HERE
- You will need a 3/64 allen wrench for the screw in the trigger pin
- You can add blue loctite to the allen screw threads when installing the trigger, however you should make sure not to get the loctite on the pin portion that goes through the trigger bar
*All triggers need to be installed by a qualified gunsmith/Glock armorer. Tacticalpontoon will not be responsible for incorrect installation. All safety checks must be verified and tested after install. *