The Peacemaker Dagger tune-up kit (Have a Micro Dagger? Here is the kit for you )
Are you tired of that hinged polymer trigger that was stolen from your grandfather’s Smith and Wesson? How about that break which creeps worse than an OnlyFans simp? Don’t fret and don’t waste your money on half ass ‘Performance’ triggers off of Ebay…. TacticalPontoon has you covered with my tune-up kit!
What do you get with this kit? Why choose TacticalPontoon?
Instead of fighting some roll pin in the trigger shoe (one wrong move and you beat up your new trigger) this kit uses the trigger from the Peacemaker which has a screw to make install a breeze! I clean up the break with a connector that just swaps into place, and while you are there, the new trigger spring clips right in…..squirt on the included Badger Snot…then hit the range to enjoy the new hotness!!!
Check out the full value of this kit below;
- Peacemaker trigger shoe
- 4lb polished crisp break connector
- overpowered trigger spring
- squeeze tube of Badger Snot
- *optional* reduced weight duty rated striker spring
- *optional* reduced weight safety plunger spring
- You will need a 3/64 allen wrench for the screw in the trigger pin Click here for an allen key
- You can add blue loctite to the allen screw threads when installing the trigger, however you should make sure not to get the loctite on the pin portion that goes through the trigger bar
- Want to make the install easier…grab a Tacticalpontoon Armorers Block
*All triggers need to be installed by a qualified gunsmith/Glock armorer. Tacticalpontoon will not be responsible for incorrect installation. All safety checks must be verified and tested after install. *